[bug] editor goes readonly - CnWizards IDE Wizards - CnPack Forum

普通灌水员

UID 4759
Digest Posts 0
Credits 79
Posts 38
点点分 79
Reading Access 10
Registered 2007-1-19
Status Offline

Post at 2007-1-19 15:16 Profile | Blog | P.M.

[bug] editor goes readonly

I know that there was a check-box somewhere to set editor to readonly mode for vcl & rtl units. The problem is, that some-times the editor goes to read-only mode on my units too. I can enter one character. then i must press code-input helper shortcut, then the editor is re-enabled and i can enter another character. repeat.
Is this known bug?
I use latest release version.

Passion (LiuXiao)

管理员

UID 359
Digest Posts 19
Credits 6838
Posts 3591
点点分 6838
Reading Access 102
Registered 2004-3-28
Status Offline

Post at 2007-1-26 23:35 Profile | Blog | P.M.

Thanks for reporting. Other users mentioned the same problem before, but we can't reproduce it reguarly.
Now no clues about it.

klemm

普通灌水员

UID 4759
Digest Posts 0
Credits 79
Posts 38
点点分 79
Reading Access 10
Registered 2007-1-19
Status Offline

Post at 2007-1-27 07:15 Profile | Blog | P.M.

It only happened with one of my project one time. I can't reproduce it either.
Will let you know if it happens again and i find a way to reproduce.

Passion (LiuXiao)

管理员

UID 359
Digest Posts 19
Credits 6838
Posts 3591
点点分 6838
Reading Access 102
Registered 2004-3-28
Status Offline

Post at 2007-1-27 12:35 Profile | Blog | P.M.

OK. Thanks. We're also looking for it, too.