I know that there was a check-box somewhere to set editor to readonly mode for vcl & rtl units. The problem is, that some-times the editor goes to read-only mode on my units too. I can enter one character. then i must press code-input helper shortcut, then the editor is re-enabled and i can enter another character. repeat.
Is this known bug?
I use latest release version.Author:
Passion Time: 2007-1-26 23:35
Thanks for reporting. Other users mentioned the same problem before, but we can't reproduce it reguarly.
Now no clues about it. Author:
klemm Time: 2007-1-27 07:15
It only happened with one of my project one time. I can't reproduce it either.
Will let you know if it happens again and i find a way to reproduce.Author:
Passion Time: 2007-1-27 12:35
